699
回編集
差分
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: enp0s9enp0s3
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: enp0s3
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 08:00:27:66:20:41
Slave queue ID: 0
Slave Interface: enp0s9
Permanent HW addr: 08:00:27:59:5c:9a
Slave queue ID: 0</syntaxhighlight>
何となくですが…動作モードは「active-backup」で「enp0s9」がスレーブに設定されている感じです。backup」でアクティブが「enp0s3」、「enp0s9」は待機しています。
ipコマンドでも確認してみます。
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp0s3: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc fq_codel master bond0 state UP group default qlen 1000 link/ether 08aa:003e:27a4:662a:20af:41 81 brd ff:ff:ff:ff:ff:ff inet 10.0.2.15/24 brd 10.0.2.255 scope global noprefixroute enp0s3 valid_lft forever preferred_lft forever inet6 fe80::3092acd6:89f54a41:4be1a7e2:eb6654af/64 scope link tentative
valid_lft forever preferred_lft forever
3: enp0s9: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc fq_codel master bond0 state UP group default qlen 1000
4: bond0: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
link/ether aa:3e:a4:2a:af:81 brd ff:ff:ff:ff:ff:ff
inet 10.0.42.16/24 brd 10.0.42.255 scope global noprefixroute bond0
valid_lft forever preferred_lft forever
inet6 fe80::a83e:a4ff:fe2a:af81/64 scope link
valid_lft forever preferred_lft forever</syntaxhighlight>
VirtualBoxの都合でdhcp設定にしましたが…。<br/>
これだけでは不安なので、以下のコマンドで「enp0s3」を殺してみます。